Crest to Crest Wave Springs
This of type wave springs are prestacked with round edge ,flat wire in series, decreasing the spring rate propotionally to the number of turns. Uses are typically applications requiring low-medium springs rates and large deflections with low medium forces, mainly used in ball valve,pressure relief valves,safety valves ,clutches ,auto clutch with bearing,gears and mechanical seals and other occasions.Unless special request ,we do not consider rotation.
Crest to Crest with Squared-shim end
Flat type wave springs, excepting the character of chest to chest wave spring, provide a entirely contact surface when compared to the wave point contact of plain ends. The flat end under load , more evenly distribute the spring force upon adjacent components. The feature is similar to the concept of double-disc grinding spring for a flat surface.
Gap Type Wave Springs
Gap type Wave Springs are usually installed in limited space. Because of its non-deformation tendency and low-medium coil force, they are more precise and reliable in performance. In bearing pre-loaded device, pre-tightening force of wave spring on bearing can attenuate noise and improve precision and stability during running of the bearing.
Nested Wave Springs
Pre-stacked in parallel from one continuous filament of flat wire. The elasticity is proportional to the number of turns. They can exert tremendous forces, yet maintain the precision of a circular-grain wave spring. In many application , Nested Wave Springs can replace Belleville Springs, particularly in cases where a high but accurate force in needed
Overlap Type Wave Springs
Overlap Type Wave Spring are used in a wide variety of applications. For short deflections and low - medium force, they function with precision and dependability.In the device of bear preload , this kind of springs can reduce the running noise of bear. and meanwhile ,they can improving the accuracy and smoothness of bears.
Based on More than 20 years technical experience, Our Wave Spring especially has its advantage in its special technics, low cost and high & steady quality.
Currently we can supply several series of products, e.g: different kinds of single-turn & crest to crest wave spring, retaining ring etc, which is widely used in machinery & equipment, chemical industry and electrical industry.
Unlike punch forming process, we use continuous winding and curling process from round edge flat wire, to realize real flexible production and in the mean while to reduce waste of material and avoid damage from stress. We endeavor to provide wave springs with super quality and competitive price. Wave Springs made from this process have accurate
elasticity coefficient and better performance. Upon completion of design, we can get different elasticity coefficient and specific performance requirement by changing number of waves, turns, free length, thickness of the material and radial width that would realize at low cost. So this process is suitable, in particular, for repeatedly trial production and optimizing new products in development.
At the same time it can avoid issues like product design, development and sample manufacturing. Not only it is convenient for sample trial production in small batch, but also it has the following features in mass production
Within our factory, we have established a full system of quality management, to ensure our quality and service, to reach the high quality requirement from national defence industry and astronic industry. We own advanced spectrum analyzer and strictly control each batch of raw material. We also use firstclass spring testing machine for precision test on loading of the wave spring, deformation, free length, elasticity coefficient etc.
We will keep our sincerity and trust, ensure the best quality to all customers, try our best to offer the marketing our best production!
Tel: +86 13355270003 Fax:
Mobile Phone: +86 13325207778
Address:5Qianlima Rd zichuan Economic deveiopment zongzibo. shandong